![]() ![]() Hardware does monitoring: when this is selected, Mixbus expects you to monitor yourself through your soundcard’s audio device or built-in mixer.However, this incurs a latency (delay) caused by the soundcard buffering, plugins, operating system overhead, and other potential sources of delay. Mixbus does monitoring: when this is selected, Mixbus will sometimes (depending on settings) allow you to hear your input signal through the mixer.In conjunction with sample rate, buffer size is used to control latency and to manage hardware resources. A drop down list with supported sample rates by your selected audio interface will be displayed with a maximum of 192k.Normally, you should choose the same or similarly-named device for both input and output. Some combinations of input & output devices will not work.For best results, you should use Mixbus with a high-quality audio interface. Select your preferred audio interface from the pulldown list.MME devices are limited to 2 channels of input and output, and incur additional latency (delay) of the audio signal. MME: use MME for built-in devices or other soundcards that do not have an ASIO driver.ASIO provides multiple channels of high quality sound, at low latency. ASIO (preferred): Dedicated audio devices (usually connected with USB or similar) should be provided with an ASIO driver by their manufacturer.This menu specifies the driver software protocol for the selected input and output devices detected. If not, then Mixbus will start the JACK server for you (the JACK option is available on Mac, Windows and Linux). If the JACK server is already running, then Mixbus will connect to the JACK server. It is only available if you have already installed JACK on your system. “ JACK” uses the JACK server to talk with your sound card and other software on your system.To use your audio devices on Linux, select “ ALSA” (these options are only available on Linux).To use your audio devices on Windows, select “ PortAudio” (this option is only available on Windows).To use your audio devices on Mac OS X, select “ Core Audio” (this option is only available on Mac).The “Audio System” selection tells Mixbus which way you will connect to your devices. The audio device must be re-started if you want to save your session. ![]() This will disconnect Mixbus from the audio device, and therefore use no cpu power. *It is sometimes useful to click the “Stop” button while you have a session open. When you are done with the settings, press the “ START” button to connect to the selected audio device. ![]() Start/StopĪs seen in the figure there is an indicator showing “ STOPPED” in red while you are setting up these parameters. You can also launch the Audio Midi Setup dialog from the main menu, under “Window”. However you can later change the soundcard setup, buffersizes, and other I/O details. ![]() *The sample rate that is selected during the initial session setup cannot be changed later. This step allows you to choose the session’s sample rate, as well as the soundcard settings and other details. The Audio Midi Setup dialog appears automatically when you create a “New” session.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |